7 Steps to Pool Maintenance in Rancho Santa Fe

7 Steps to Pool Maintenance in Rancho Santa Fe

If you live in Rancho Santa Fe and own a swimming pool, you know how important it is to properly maintain it if you want to get the best use out of it. Proper maintenance will keep your pool clean; it will also ensure its equipment and tools are in good condition.

To help you do a good job of pool maintenance, we have provided the steps you can follow below. Alternatively, you can opt to have our company do your pool maintenance in Rancho Santa Fe.

Let’s get started!

Step One: Remove Debris

Begin your pool maintenance by skimming all floating debris on the surface of the pool and emptying the skimmer basket. Ensure you dispose the waste far from the pool to prevent it from getting tracked back inside.

Step Two: Vacuum the Pool

When your vacuum is set up, use it to thoroughly to clean the pool. Note that the most efficient way to vacuum a pool is by slowly go across in the pool in overlapping parallel lines. This is similar to how you would mow a lawn. Keep in mind that the average pool requires about 30 minutes of vacuuming for thorough cleaning.

Step Three: Adjust the Chemical Level

The chemical composition of a pool is vital as it determines whether or not the pool is safe for use. Because of this, you have to test the chemical composition regularly (preferably weekly), to know when it requires adjustment.

pH level: If your pool’s pH level is higher than 7.6, correct it with muriatic acid. If it is less than 7.4, apply soda ash product.

Chlorine level: If the pool’s chlorine level is less than 1 part per million (ppm) or alkalinity level is below 90 ppm, shock the water. To do this, dissolve chlorine and/or an alkaline increaser, such as baking soda, in a bucket of water. Then, pour the water in the pool.

Step Four: Backwash the Filter

Backwash the filter by turning the filter valve to redirect the water flow.

There are three major types of filter: sand, cartridge, or diatomaceous earth (DE) filters.

  • In the sand filter, sand blocks dirt and oil. Then, the backwash transfers the dirty water to a waste line that connects to a storm drain or the ground.
  • In the cartridge filter, remove the filter unit to hose all the dirt off. Then, reinsert it.
  • In the DE filter, the claylike remains of sea organisms block the dirt, which the backwash directs into a filter bag. Ensure you empty the filter bag every two weeks and replace after a few years.

If you use a sand filter, endeavor to replace it with a DE or cartridge filter system as they save water, filter more efficiently, and are more environment-friendly.

Step Five: Regularly Clean the Pump Filter

Before you clean the pump filter, turn the pump off. Then, close the skimmer valve before the pump to make it hold water, thus avoiding repriming the system when you want to start it up. Afterwards, unscrew the cover and throw away the content of the ba

Step Six: Add Chlorine to the Pump System

You can add chlorine to your pool either through a chlorinator or a floating container. However, ensure the floating container cannot be stumbled upon by small children as it is dangerous to their health.

Step Seven: Check Water Level

Finally, check the pool’s water level to know whether to refill it or not. If it has fallen below the halfway line of the skimmer well mouth, then you should refill it. Otherwise, leave it be.

If these tips seems a bit overwhelming, do not worry! Hiring a company that does weekly pool maintenance can make life easier for you! POOLSERV is a top-notch swimming pool company near Rancho Santa Fe. you can make use of.  Get an instant quote from us today! Contact us at 858-707-7589 to get started today

(858) 240-9770
Have a question? Give us a call!
Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on pinterest
Pinterest